bullet7 ea. 8mm nuts around the inside of the fender lip; these hold on the outer trim piece as well.  Picture
bulletremove all the nuts
bulletremove the outer trim piece.

Note that the following screws may have been replaced with different types (Phillips head, etc).  The plastic anchors tend to strip out with use, so replacement with larger diameter screws is not uncommon.

bulletSix 8mm screws in the wheel well.  Picture 
bulletOne at the top center, near the spring/strut assembly
bulletone at the center, looking directly into the wheel well, behind brake line
bulletone at the front corner, about 6" from the bottom (this one could use a 1/4" ratchet, or an 8mm open end wrench, as it's difficult to get to with a driver handle)

 
bulletThree underneath
bulletthe front one at the corner may be 10mm, not 8mm
bulletthe other two are progressively farther back from the front corner of the wheel well

 

bulletRemove the front inner fender liner.
bulletDisengage it from the fender lip at the top center and it will fall out

Use the browser's BACK arrow